60W CO2 Laser Power Supply for CO2 Laser Engraving Cutting Machine MYJG-60W PSU Malaysia

60W Bekalan Kuasa Laser CO2 untuk Mesin Ukiran & Pemotongan Laser CO2 MYJG-60W PSU – Stok MalaysiaCO2 Laser Power Supply for 60W laser tube. (can use for 50W / 80W laser tube too)Warranty: 3 Months upon manufacturing defects1. Zero current half-bridge soft switch circuit, the power supply is featured by high efficiency and rapid response, and easy to match laser tubes of manufacturers.2. It has simple port control, fits high and low level signals, can control laser start and stop through TTL level, and is equipped with abnormal protection switch to detect if there is water or ventilation outside.3. Laser power can be regulated by inputting 0-5V simulation signal or inputting PWM signal.4. The power supply has open circuit protection function: Under the condition of good earthing protection, the power supply can work in open circuit in short time, and then it can avoid the damage caused by laser tube cracking.5. Ex-factory aging test Each power supply can undergo a 12h aging test at high temperature of 60ºC on full load, and 500 times of 7sec power-on/off tests.